Se Electronics Dm2 Tnt For Dynamic And Passive Ribbon Microphones.

Switchable, clean and consistent gain from moderate +15dB to explosive +30dB
designed for neutral, balanced sound quality with minimal noise

explore eight settings ranging from an unconventionally low 50 Ω to stunningly high 10 MΩ to match your preamp with any mic accurately

two gain levels for even higher flexibility on various sources

ruthlessly boosts the signal independent from load impedance or cable length

DM2 TNT
Frequency Range: 10 Hz – 120,000 Hz (-0.3 dB)

Gain: 15 dB / 30 dB

Max output level (0.5% THD): 9.5 dBV (3.0 V)

Output noise level: 1 μV @ 15 dB / 6.6 μV @ 30 dB

Powering: 48 Volts according to IEC 61938

Electrical impedance: 135 Ohms

Recommended load impedance: >1k Ohms

Current consumption: 3.1 mA

Connectivity: 3-pin male/female XLR connector

Dimensions: Diameter: 19 mm (0.75 in.) Length: 95.5 mm (3.76 in.)

Weight: 80 g (2.82 oz.)

SYSTEM REQUIREMENTS
REQUIREMENTS
input: passive microphone (ribbon/dynamic)
output: preamp/mixer/audio interface providing 48V phantom power
LIMITATIONS
not suitable for phantom-powered microphones (condenser microphones, active ribbon microphones)